Selecting The Ethernet Interface
By selecting the Ethernet interface you will be uploading the time schedule to the board through your local area network or internet. Boards on this page are equipped with a Lantronix communications module that adds Ethernet communications to the board. The board will plug directly into your router where it is assigned an IP address. Once the IP address has been assigned the board can be discovered on the network using the included Base Station software. Using Base Station you can configure your time schedule and upload it to the board.
Selecting an Ethernet Relay Board
Below you will find the 4-channel Time Activated Ethernet Relays that are available. The difference being the amperage of the relays installed and the type of relay. Choose the controller that fits the amperage you are switching. You will find SPDT relays in the 5, 10 and 20 amp versions and an SPST version in 30 amp. A solid state version is also available. For more information on selecting the correct relay for your application see Choosing a Proper Amperage
Easy Board Selection
Shop Time Relays Here
TaraList: Time Controlled Relays
Time Schedule Activated Relays with Computer Interface. Use a Computer to Setup the Time Schedule.
Taralist Series Controllers do not require a computer after initial configuration.
Manually Take Control of Relays from Anywhere in the World using a Computer as needed.
Find the board you need by using the interactive menu to he right. Hover over the Button and select the number of relays you want installed and then select the computer interface you need. Once there simply select the board with the correct amperage for the item you are switching.