No Computers, No Configuration, Works Right out of the Box
Every MirX controller is equipped with contact closure inputs and outputs. The inputs on one controller activate the relays on the remote device using wireless communications. The "X" in MirX refers to the crossover. Since both devices are equipped with contact closure inputs and relays, each device targets and controls the remote device.
Every MirX controller is equipped with a Busy/Ready LED. If the Busy LED flashes, this indicates the remote device has successfully received and accepted your contact closure status. If the Busy LED does not flash, the remote device is out of range.
MirX devices are only sold as a permanently married pair, pricing shown on our web site indicates pricing for the pair of controllers. Contact Closure Inputs may only be connected to switches, buttons, or sensors with Contact Closure capability. Not suitable for use in voltage detection applications.
The MirX Series Relay Controllers are ready to go to work immediately out of the box. No Computers, No Configuration, Just Simple, Reliable Wireless Communications between two devices that permanently work together
as a married pair.
MirX devices use 802.15.4 two-way communications to ensure the remote device is properly functioning. The Busy LED is always used to indicate a properly functioning remote device. If you do not see the Busy LED flash, then the MirX controller is unable to communicate to the remote device. A flashing busy LED is your verification that all communications are functioning properly between MirX controllers.
Customers who require inductive switching (such as motors, lights, pumps, solenoids, and Transformers) should visit the Induction Suppression portion of our web site.
New Board Designs
The new Reactor Relay Series features our new surface mount LED lights. These lights are smaller and brighter than previous generation lights for making relay status easier to read at a glance. The Reactor Relays will also feature a new board design with Break-Away Tabs. With the Tabs on, the board will fit into an enclosure. If your project requires a smaller profile without an enclosure, simply snap off the tabs on each side for a smaller board.
Interfaces between the tow devices will be 802.15.4 and the communication between the two devices permanently work together as a married pair.
MirX Series Features:
Sold in Pairs
Contact Closure Inputs and Outputs at Each Location
Each Device Controls the Other Device
Local Inputs Control Remote Relays
Remote Inputs Control Local Relays
2-Way Communication with Verification
No Configuration
No Computers
No Programming
Beacon Mode for Range Testing
Smart Mode for Fast, Low Power Operation
4 Channel MirX Relay with Break-Away Tabs
4 Channel MirX Relay with Tabs Broken Out
4 Channel MirX Relay Without Break-Away Tabs
Articles
New to MirX Controllers? Click the following links for helpful wireless articles to get you started.
Our 8 Channel MirX Relays are always sold in married pairs and feature
SPDT & SPST and Solid State relays and are available with eight contact closure inputs on each board. The MirX Series Relay Controllers are ready to go to work immediately out of the box. No Computers, No Configuration, Just Simple, Reliable 802.15.4 Wireless Communications between two devices that permanently work together as a married pair.
For more detailed information, video, manuals and to order, please click on the links below.
Retail Software
RS232 Relays
USB Relays
ZB ZigBee Relays
Bluetooth Relays
Fiber Optic Relays
Web Relays
WiFi Relays
Contact Information
